LEDStandby "OFF" WITH ON LED PLUG A. The compact, discrete size makes it a nearly invisible way to detect motion, so it will not detract from the style or architecture of the protected area. A ceiling mounted motion detector helps minimize vandalism, especially when being used in a public place. Possibly due to repositionedCapability: Power source should be capable of at least INSTALLED. Remember that as a ceiling mount motion, it looks in a circular pattern, rather than scanning across the room. If you continue browsing the site, you agree to the use of cookies on this website. Optimal performance is achieved when the detector is mounted on the ceiling in the center of the protected area. This may be difficult if you are not used to wiring. To replace the cover, align the tabs on the covers edge with the notches on the bases rim, press the cover gently in, and turn it clockwise (to the right). Clipping is a handy way to collect important slides you want to go back to later. Passive Infrared Motion Detecting Sensors, Honeywell PIR Motion Detector Comparison Chart. The 997 should not be installed in areas that may be prone to rapid temperature change, close to heating and cooling systems or in areas that expose the detector to direct sunlight. *86: On all control panels from 4140-4140XMPT2, Vista-40, and Vista-50, *86 allows a single 4208 to operate as zones 10-17. a. RELAY COVER IS WARRANTY INFORMATION 12V REMOVED).Dimensions: 3-1/2” (89mm) diameter x 1” (25.4mm) high. 997 Ceiling-Mounted Passive Infrared Motion Detector INSTALLATION INSTRUCTIONSGENERAL INFORMATION 3. Units should never be relocated without the advice or desired (plug in place). Installation manual for the Honeywell 997 ceiling mount PIR motion detector. With INTERMITTENT OR CONTINUOUS ALARM cover on, the switch is closed; when cover is removed, the Probable Causes: switch opens. MAINTAINING PROPER OPERATION Figure 1. endstream endobj 2526 0 obj <>/Metadata 70 0 R/Outlines 110 0 R/PageLayout/OneColumn/Pages 2521 0 R/StructTreeRoot 584 0 R/Type/Catalog>> endobj 2527 0 obj <>/ExtGState<>/Font<>/XObject<>>>/Rotate 0/StructParents 0/Type/Page>> endobj 2528 0 obj <>stream 0 If furniture or stock is moved, Remove the LED enable/disable plug. The Honeywell 997 is a wired passive infrared motion detector that is designed to be mounted on the ceiling of a room. When mounted on a ceiling at 11’ high, the 997 has a 360 degree look-down view that covers an area of 36’ in diameter. 2622 0 obj <>stream To prevent the loss of the plug, we power available for at least 4 hours of operation during (5.5m) (3.5m) CONSISTS OF TWO emergencies. If pulse count is to be used in this installation, install the• Make sure the detection area does not have obstructions pulse count jumper plug on the pulse count pins, and (curtains, screens, large pieces of furniture, plants, etc.) Where Should I Install My Motion Detector? FIELDS (INCLUDING suggest you install it on one pin when the plug is not in use. Ademco has been a pioneer in the use of Surface Mount Device (SMD) construction in the security industry. conditions lasting for approximately 1 to 3 seconds LED INOPERATIVEMounting (dependent upon signal strength).